How to Tighten Tension Wire on a Chain Link Fence




You decided to build a chain link fence. You have the posts set. You already figured out how to get the rail ends on and have the top rail in place. Now its time to put the bottom tension wire on. No matter how hard you try or how hard you pull the wire, you just can’t seem to get it tight.

The shared wire used as bottom tension wire on chain link fencing is a 9 gauge galvanized wire. It usually comes in rolls of 170′ or more. The wire is thick, heavy, and is difficult to stretch. Here is a simple way to tighten the wire, and all you need is a pair of pliers. Start by attaching one end of the wire at a terminal post (also known as an end post or corner post). Put the wire by the brace band and wrap it around it’s self a few times. It is not recommended to try and pinch the wire in the brace band to obtain it. Roll the wire out along the fence line.

Cut the wire a associate feet past the next terminal post you are securing it to. Walk the fence line again and make sure the tension wire has no kinks, is not caught on any roots or under growth, and get out as many of the “loops” (caused by it being rolled) as you can. Take the free end of the tension wire and thread it by the brace band at the terminal post you are going to attach too. Pull the wire as tight as you can get it, and wrap it around itself a few times as you did at the first post.

The wire should be fairly tight, but may push away from the posts about a foot. Tighten your brace bands. Take your pliers (lineman pliers work best) and grab the tension wire with the pliers by either one of the terminal posts. With a firm grip, twist the pliers to the left or right. The tension wire will form a “z” were you twisted. Work your way down the fence line twisting the tension wire in this matter at every post.

You will notice the further you work down the line, the harder the wire is to twist. This is due to the wire getting tighter and less slack being able to be twisted. Put as many twists in the wire as needed to unprotected to the tension you desire.

This is a simple way to tighten bottom tension wire and make sure the bottom of your chain link fence is obtain.




leave your comment

Top